Omar VOYAGE-DE-NUIT

En résumé

Entreprises

• Sonatrach / Hess - Hydrocarbon Accounting and Allocation

  2011 - 2016 * Check all parameters before entering the data into the calculation system.
  * Validation the daily calculation parameters by entering crude (oil) parameters such as:
  -Volume produced 24 hours back which should be calculated with density of 15°C in accordance to the international norms crude export.
  -Check with laboratory for validation RVP, Salinity, Water and Sediments.
  * If abnormal production, immediate investigation with production department.
  * Compare previous balance oil storage, daily production and export to check any deviation.
  * Calculating water oil ratio "WOR".
  * Calculating gas oil ratio ``GOR". ;
  * Calculating water, gas miscible, gas-lift injection and dilution water.
  * Calculating fuel gas consumption by turbines, seal gas compressors and flares.
  * Potential wells evaluation after test. ;
  * Monitoring and evaluation by field the daily production.
  * Liaise with production, exploitation and finance departments.
  * Follow up evolution between forecast values with achievements.
  * Submit daily report including changes in maintenance and wells operations such as wire line, snubbing
  and work over, including the daily production.
  * Provide suggestions and improvements to the allocation and reporting procedures. ;
  * Complete day to day the monthly report and calculation. ;
  * Annual balance comparison between forecast / realization (gas lift, gas miscible, water injection and oil production) with analysis reservoir fields evolution.

• SONATRACH - CONTROL ROOM OPERATOR

  1998 - 1998 CONTROL ROOM OPERATIONS SKILLS:
  
  *Control room Operator, operating General Electric turbines using Mark-2, Mark-4 and Mark-5.
  *DCS Yokogawa, Foxboro, and delta V Emerson monitoring and controlling flow, pressure, temperature and compressors anti surge limits.
  *Expert in monitoring manually anti-surge Nuovo Pignone compressors valves in urgent situations.
  * Pre-commissioning, commissioning compressions units with JGC Corporation and Pignone taken the revamping operations responsibilities in start up and shut down until the units run safely.
  *Investigating regulation loops failure and Speed-Electronic signals contacts.
  *Start up and shut down operations with safe procedures and loading gradually till stabilization of the process units.
  *Monitoring and control all parameters such as pressures, temperatures, levels and flow rate respecting load sharing philosophy.
  *Monitoring loops and detects any trend deviation due to an abnormal effect.
  *Reset all contacts and refresh software data before starting.
  *Monitoring RVP "Petrofac" unit heating by glycol threw boiler.
  *Monitoring continually Oil separation, settling, storage and export.
  *Monitoring Water treatment and water injection unit.
  *Monitoring air instrument and nitrogen seal gas.
  *Monitoring miscible gas and gas lift compression units according to the anti-surge range limit, and check vibrations and noise control.
  *Share investigation and troubleshooting with maintenance team.
  *Check P&ID if any circuit modification.
  *Give a call to the ambulance team attendance in case of injuries to rescue.
  *Recording permits to work and all work events with full details description.
  *Good knowledge of the electronic cabinets switches contact to power off in case of electrical fire.
  * supervising by cameras flares and hot locations of machines.
  *Solving problems intuitively in case of emergencies and fire with given alert to the rescue team.

• SONATRACH/SONAHESS - Chef suivi de production

  1989 - maintenant

• SONATRACH - PROCESS OPERATOR

  1989 - 1997 Operator Position Skills:
  
  *Working day and night shift operator in gas compression injection facilities, where work routine needs rigorous
  control of the equipments such as pipes, turbines, compressors, oil and gas coolers because of gas leaks and
  warm atmosphere, especially in hot summer season in the desert locations where the atmosphere is statically dangerous.
  *Investigation the various noises.
  *Check parameters and advice the site controller engineer when something is wrong such as pressures, temperatures or flows...
  *Control the maintenance works according to the safety rules, such as cold and hot works, mechanic and electric isolation.
  *Start up and shut down operations according to the prior procedures in step by step.
  *Emergencies shut down in case of fire or threaten gas leak.
  *Give alerts with radio to the control room when something abnormal arrives.
  *Short round inspection of the electrical substations.
  *Control extinguishing cabinet system (CO2 and POWDER) electro valves position after long shut down.
  *When the system fire detection hits (normally / accidentally), immediate control of the location and look for some one who may risk injured by suffocation.
  *Share all operation advices with the shift team.

Formations

• INH (Angers)

  Angers 1986 - 1989

Réseau

• Aicha JELOUANE

• Franck LAGATHU PRO

• Manon ALIX

• Ouarda Didouche TOUMI

• Souheil LEMMOUCHI

• Vtc Lyon LYON-CHAUFFEUR-PRIVE.FR

• Wing Fa VOLTE

• Zouina AIT CHIKH