Menu

Paolo LUCCHI

PARIS

En résumé

Paolo LUCCHI received the B.S. and the M.S. degree in Electronics Engineering from Università degli Studi di Modena and Reggio Emilia, Italy, in 2005 and 2008, respectively. Then, he obtained the Ph.D. degree in Physics Science and Engineering (Micro-Electronics) from the University of Bordeaux, France, and the Ph.D. degree in Information and Communication Technology from the Università degli Studi di Modena and Reggio Emilia, in February 2012 (Italy-France joint doctorate program).
In 2010 and 2011, he was a Ph.D. Fellow with the IMS Laboratory, Bordeaux, France. Since 2011, he has been a Analog RF and mmW Engineer with the IC Design Team, Bordeaux, France.
His research interests mainly focus on the Analog Design and Modelling at millimeter wave frequencies (mmW).
Since Juanary 2012 Dr. Paolo LUCCHI is Analog RF and mmW Design Engineer at United Monolithic Semiconductors, Paris, France. His research activities are focused on the design of BiCMOS RFICs for automotive radar applications.

Entreprises

  • United Monolithic Semiconductors (THALES - AIRBUS jv) - R&D Engineer

    2012 - 2015 - Design of 24 GHz single channel receiver in BiCMOS SiGe 0.18 μm technology for automotive radar
    applications -
    Design of 20 MHz Serial to Parallel Interface in BiCMOS SiGe 0.18 μm technology
    -Design of 79 GHz four channels receiver in BiCMOS SiGe 0.18 μm technology for automotive radar
    applications

  • IMS - Research Engineer

    saint priest 2009 - 2011 -Design of a Voltage Controlled Oscillator and division chain for a 60 GHz Phase-Locked Loop in CMOS 65 nm Technology for WPAN applications. The project was carried out at the IMS laboratory (Bordeaux, France) in collaboration with the LAAS Laboratory (Toulouse, France)
    -Collaboration with the Polytechnic of Nice and Entropic Communications company (Sophia An- tipolis, France) where I spent two months of internship to work on Digital Phase-Locked Loop in 65 nm CMOS Technology

  • MeMiTec Laboratory - Research Engineer

    2009 - 2009 -Collaboration with Ewings company (Bologna, Italy) for the layout of Phase-Frequency Detector in 0.35 μm CMOS Technology
    -Design of a 15 GHz Quadrature Voltage Controlled Oscillator in 0.13 μm CMOS technology

  • C.f.r.Italy s.r.l - Engineer

    2008 - 2008 -DC electric motors: wound field and permanent magnet
    -AC asynchronous motors
    -electro hydraulic pumps for lifting, electro hydrsulic pomp for steering, motor in wheel unit and steering gear motor

  • Silis - Analog and RF ICs design engineer

    2008 - 2008 -Experimental measurements on low frequency noise spectra ( 1\f and corner frequency) on deep sub-fmicrometric CMOS techs (i.e. 65 nm). Expertise on laboratory testbench setup and microprobingfor direct measurements on wafer
    -Skill cadence computer planning for the test and the characterization of 45 nm Technology

  • MeMiTec Laboratory - Junior Design Enginner

    2007 - 2008

  • MeMiTec Laboratory - Junior Design Engineer

    2005 - 2005

Formations

  • Università Degli Studi Di MODENA E REGGIO EMILIA (Modena)

    Modena 2009 - 2011 Ph. D.

    microelectronics/semiconductors

  • Université Bordeaux 1 Sciences Et Technologies

    Talence 2009 - 2011 Ph. D.

    microelectronics/semiconductors

  • Università Degli Studi Di MODENA E REGGIO EMILIA (Modena)

    Modena 2005 - 2008 Master of Science degree in Electronic Engineering

    Electronic

  • Università Degli Studi Di MODENA E REGGIO EMILIA (Modena)

    Modena 2000 - 2005 Bachelor of Science degree in Electronic Engineering

    Electronic

  • F. Corni (Modena)

    Modena 1995 - 2000 Secondary-school diploma

    Electrical and industrial automation

Réseau

Annuaire des membres :