Menu

Sraj IBRAHIM

JEDDAH

En résumé

BMS Engineer (Building Management Systems)

Mes compétences :
Administration
ccna
Gestion de projet
Hyperfréquence
Informatique
Matlab
Routage
Sécurité
Sécurité réseaux
Solution informatique
Supervision
Telecom
VHDL
VoIP

Entreprises

  • Advanced Vision (Saudi Bin Laden Group) - BMS Engineer (Building Management Systems)

    2014 - maintenant KAIA Project (King Abdul-Aziz International Airport) – Jeddah, KSA
    The BMS system was serving for all mechanical systems which consisted of:
    - Air Handling unit
    - Chiller Systems
    - Chilled water pump system
    - Exhausts Fans, AHU, FCU, VCU, VAV and CAV
    The BMS System was able to monitor through Graphic work station.
    Duties & Responsibilities:
    Coordination with technical section, management and making work plan
    Supervision of complete project area for:
    - Programming
    - Commissioning
    - Installation
    - Structural cabling
    - Termination
    - Logic developing for DDC controller

  • Agc ( All Generations consultant) - RF optimization/drive test Engineer

    2013 - 2014 - Perform field testing and gathering log files using drive test tools measuring the performance of signal coverage and base station sites, Analyzing drive test logs and reporting
    - Network audit(data collection, Analysis) .
    - Tracing and micro troubleshooting (GSM, WCDMA and LTE)
    - Frequency and cell Planning
    - New sites acceptance, neighbor optimization, scrambling code collisions
    - Maintaining and Improving all Radio performance KPIs (Voice and Packet)
    - End users complaints handling (Bad coverage or quality, Drop calls, etc.)
    - Monitoring and analyzing the GSM radio Network statistics on daily basis.
    - All Radio Optimization Activities that included: Physical Optimization (Antenna – Azimuth and tilt tuning),
    - HW problems handling and troubleshooting (Alarm clearing and health checks)
    - SW tools: Post processing tools (MapInfo, Actix, TEMS, NEMO, etc.)

  • France Télécom - R&D engineer at France TELECOM

    2012 - 2012 Development of an emulation code to navigate in an air’s network, optimization of energy consumption via the routing aspects OLSR (Optimized Link State Routing) and simulation through the NS-3 simulator (Network Simulator)

  • IDIL Fibres Optiques - Assistant Engineer at IDIL (FIBER OPTIC)

    Lannion 2011 - 2011 Development of a fuel injection system for a laser pulsed YAG by developing an electronic card from the detection of an optical pulse from the laser to shaping the signal using software IAR.

  • Université de Limoges - Projet académique

    Limoges 2010 - 2010 Principe de fonctionnement, Caractéristique électrique et schéma équivalent, Simulation et exploitations des résultats en variant les paramètres de la cellule, réalisation et fabrication d’une cellule photovoltaïque optimisée à haut rendement

  • Agc ( all generations consultant) - Training Drive test engineer

    2009 - 2009 General study of GSM 2G/3G networks using telecom tools called Tems and monitor the performance of the network in several areas (TEST DRIVE)

  • OGERO - Training at the Lebanese Ministry of Communications OGERO

    2008 - 2008 - PSTN Networks
    - Cabling systems
    - Transmission systems (SDH/PDH)
    - Fiber optics
    - Wi-Fi
    - WiMax
    - Proxy server (cache)
    - WAN/LAN
    - Router's configuration

Formations

  • ENIB Ecole Nationale Des Ingénieurs De Brest (Plouzane)

    Plouzane 2010 - 2012 Ingénieur généraliste

  • Université Limoges

    Limoges 2009 - 2010 Master 1

  • Lebanese University (Beirut)

    Beirut 2006 - 2009 License

  • Collège Universel De Marj-Ali (Shhim)

    Shhim 2005 - 2006 Baccalauréat

    série scientifique - sciences générales

Réseau

Annuaire des membres :